Sunday, July 24, 2011

Thanks for the Bottle Caps

I love when inspiration arrives via USPS. My sister, Noel, follows my posts on the Crystal Lacquer Blog and thought I might be able to use 7 Fitz's Premium Root Beer bottle caps.

Yummy, this project was bit like eating good candy. I couldn't stop at just one bottle cap.

What is nice about the Fitz's bottle caps is that they are a twist off, so the shape is not distorted.

Several pieces of inspiration were found at Zinnia in South Pasadena, including this old broach. I used an Exact-O knife to remove the remaining faux diamonds. Be VERY careful doing this as I nicked my finger and don't recommend the experience.

You begin to see where I am going, when the bottle cap fits perfectly within the broach setting.

The picture below is not in focus; however, I wanted to show what the Pearl Color 3D Crystal Lacquer looked like dropped into each individual slot.

In the bottle cap itself, I used an image left over from my last "Film Noir" project. I covered the image with Yellow 3D Crystal Color Lacquer - Glitter Primary to give it a little sparkle. Once everything was dry (give it time to dry!), I glued the pieces together and applied a pin back.


As I mentioned above, I could not stop at 1 bottle cap. I had all sorts of "found" objects and 3D Color Crystal Lacquer to play with.

A cool looking bead set into Glitter Violet 3D Crystal Color Lacquer.

Blue 3D Crystal Lacquer with Metallic Blue swirled in. Dolphin pieces were applied after the blue swirl layer dried.

The small fancy glass piece was left over from a prior project and had been stamped with the butterfly image. Not that you can tell from the image, but a layer of Pearl 3D Crystal Lacquerwas applied underneath. Then the glass piece, followed by the small square frame on top.

Glitter Yellow 3D Crystal Color Lacquer and small plastic flower placed after first layer dried.

Ready for Halloween? Orange Glitter Primary & black spider. Creepy!

Below is my absolute favorite piece . . . of all the bottle caps.

The image inside the cap is from Bottle Cap Images - Vintage Edition. Covered with a layer of3D Crystal Lacquer. I attached the crown using glue and used a bail at the bottom to add the pearl drop. All of the bails used for this project were from Sakura Craft.

Keep on feeding your Creative Soul!
~Heather Morrow

2 comments: